Remove the front output shafts (on the mobile lifting table)

Remove the sealing cap (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (1) .
Remove the swivel bearing (2) and set it aside.
Hold the swivel bearing (3) with the workshop crane 2 220 718 .

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screw (1) .
Tilt the swivel bearing (2) slightly forwards in the direction of the arrow.
Loosen and remove the output shaft (3) at the front axle differential with a suitable tool.

Courtesy of BMW OF NORTH AMERICA, INC.
Install the stand (1) of the swivel bearing.
Tighten down screws (2) .

Courtesy of BMW OF NORTH AMERICA, INC.