Remove oil pump

WARNING: Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly .
Danger! Immobilization period-threatening injuries!

Observe safety instructions on raising the vehicle using a vehicle hoist.
For additional information see: RAISING THE VEHICLE WITH A VEHICLE LIFT .

WARNING: Hot fluids .
Risk of scalding!

Conduct all work in the vehicle wearing appropriate personal protective equipment only.

NOTE: RISK OF DAMAGE
Engine damage caused by excessively filling the engine with motor oil .
Filling an excessive quantity of motor oil may cause engine damage .

Observe the exact motor oil filling capacity.
Allow engine oil to drip off when draining.

NOTE: TECHNICAL INFORMATION
Make sure the vehicle is operating temperature for engine oil service (engine oil temperature > 70°C).

Preliminary work

Refer to REMOVING THE UNDERBODY PROTECTION OF THE STEERING GEAR AND THRUST FIELD RESPECTIVELY .
Refer to RELEASING THE OIL DRAIN PLUG .
Refer to REMOVING THE STIFFENING PLATE .
Refer to REMOVING LOWER OIL PAN SECTION .

Loosen screw (1) .
Remove the oil snorkel (2) .

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (1) .
Remove the pressure oil line (2) .

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Only G05 and G07
On vehicles with an active stabilizer (ARS), the fan cowl must be removed to crank the engine.
For additional information see: 17 11 035 REMOVING AND INSTALLING/REPLACING FAN COWL WITH ELECTRIC FAN .

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen screws (1) .
If necessary, the engine on the central bolt must be rotated clockwise to guarantee accessibility of the bolts (1) .
Remove the sprocket wheel (2) .
Protect the oil pump (3) from falling.
Loosen nuts (2) .
Loosen screw (1) .
Remove oil pump (3) .

Courtesy of BMW OF NORTH AMERICA, INC.