Removing the catalytic converter for cylinders 1 to 6
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING RIGHT INTAKE SILENCER HOUSING .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
- Refer to REMOVING THE SEAL FOR THE HOOD REAR .
- Refer to REMOVING LEFT AND RIGHT WIPER ARM .
- Refer to REMOVING THE COWL COVER .
- Refer to REMOVING TRAILING LINK AT SPRING BOLT .
- Refer to REMOVING THE COWL UPPER PART IN THE CENTER .
- Refer to REMOVING THE RIGHT THROTTLE BODY .
- Refer to REMOVING TOP RIGHT CLEAN AIR PIPE .
- Refer to REMOVING RIGHT CHARGE AIR PIPE .
- Refer to REMOVING THE LAMBDA OXYGEN SENSOR .
- Refer to REMOVING THE RIGHT OXYGEN SENSOR MONITOR .
- Refer to REMOVING THE REAR DIFFUSER .
- Refer to REMOVING THE TRIM FROM THE REAR BUMPER PANEL .
- Refer to REMOVING BOTH EXHAUST TAILPIPE TRIMS .
- Refer to REMOVING THE CONNECTING SUPPORT FROM THE TUNNEL .
- Refer to REMOVING EXHAUST SYSTEM .
- Unfasten circlip (1)
.
- Loosen screws (1) .
- Remove the rear underbody protection (2)
.
- Loosen nuts (1) .
- Remove heat shield (2)
on right from transmission.
- Loosen screws (1).
- Loosen screws (1).
- Remove holder (2)
.
- On vehicles without gasoline particulate filter
Loosen screws (1) .
- Guide catalytic converter (2)
for cylinders 1 to 6 down and out and remove.
- On vehicles with gasoline particulate filter
Loosen union nut (1) .
- Release the line to the differential pressure sensor from the catalytic converter.
- On vehicles with gasoline particulate filter
Loosen screws (1) .
- Unclip the line (2) to the differential pressure sensor from the holder of the catalytic converter.
- Guide catalytic converter for cylinders 1 to 6 down and out and remove.