Installing the coolant line between the cylinder head and the coolant pump

• Check the sealing rings (1)  and (2)  for damage and replace the coolant line (3)  if necessary.

  Parts:  Sealing ring

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: TECHNICAL INFORMATION 
  When assembling, it is essential to observe screwing sequences and tightening torques.
  Failure to comply with the regulations can lead to leaks and damage.
• Feed in and install coolant line (2)  .
• Hand-tighten the bolts (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1)  .

Follow-up work 

• Refer to INSTALLING CHARGE AIR LINE .
• Refer to INSTALLING BOTTOM CLEAN AIR PIPE .
• Refer to INSTALLING CLEAN AIR PIPE, TOP .
• Refer to INSTALLING THE INTAKE FILTER HOUSING (TENSION STRUT REMOVED ON SHOCK TOWER) .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING FRONT CROSS CONNECTION (FRONT-END STRUT REMOVED) .
• Refer to INSTALLING BOTH FRONT-END STRUTS .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .
• Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .