Installing the electrical vacuum pump

• Install the vent hose (1)  in arrow direction.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position electrical vacuum pump with holder (2)  .
• Replace screws (1)  .

  Parts:  screws.

  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Electrical vacuum pump holder to body
  M6 Replace screws.		8 Nm

• Insert screws (1)  and tighten.
• Hook the vacuum line into holders (3)  .
• Position snap fastener (2)  and lock.
• Connect connectors (1)  and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE UNDERSHIELD ON THE RIGHT FRONT SIDE .
• Refer to INSTALLING REAR SECTION OF THE FRONT RIGHT WHEEL ARCH COVER .
• Refer to MOUNTING THE WHEEL .