Adjusting Rear Lid Lock

• Lever out the covers (1) on the marked recesses (arrows) with a screwdriver and remove them.
• Loosen screws (2) until the tailgate lock can be shifted.
• Adjusting tailgate lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Check 

• Check the gap dimensions between the trunk lid and the bumper cover.

  Courtesy of BMW OF NORTH AMERICA, INC.

  Result 

  » Gap dimensions do not correspond to the specifications.

  Measure

  • Adjust tailgate latch.
• Tighten down screws (1).

  TIGHTENING TORQUE SPECIFICATIONS 

  Tailgate lock to body
  M8x20 screw	Tightening torque	19 Nm

• Clip in the covers (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Adjust stop pad (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALL THE TRIM PANEL OF THE TAILGATE HINGE ON THE LEFT .
• Refer to INSTALLING THE REAR VIEW CAMERA .
• Refer to INSTALLING THE TRIM STRIP TO THE CENTER OF THE TRUNK LID .
• Refer to INSTALLING THE TAILGATE TRIM PANEL .
• Refer to INSTALLING TRUNK COMPARTMENT LIGHT ON TRUNK LID .
• Refer to INSTALL THE POWER TAILGATE SWITCH .