Adjust Front Door
Preliminary work
Follow-up work
NOTE:
TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: 41 00... Gap dimensions for body
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: 41 00... Gap dimensions for body
Check
- Check gap dimension between front door and the adjacent body parts.
Result
» Gap dimensions do not correspond to the specifications.
Measure
- Adjust the front door.
- Open the front door.
- Slacken screws (1) until the front door can be shifted.
- Adjust the height (Z) of the front door.
- Adjust the width (Y) of the front door.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Front door to door hinge | ||
| screw | Tightening torque | 19 Nm |
Adjust lock striker
Precondition
The screws on lock striker are loosened so far that the lock striker can still be shifted.
NOTE:
TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: 41 00... Gap dimensions for body
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: 41 00... Gap dimensions for body
- Adjust the height of the lock striker so that the door lock does not bump or drag.
- Move lock striker sideways in order to adjust the gap dimensions between door and rear quarter panel.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Lock striker | ||
| screw | Tightening torque | 21 Nm |