Preparing New Part
- Mark and make the separating cuts on the new part in accordance with the separating cuts on the vehicle.NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Welding in reinforcement plates (sheet steel) - Prepare reinforcement plates for separating cuts.NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Spot-weld bonding steel components - Adjust new part and prepare for joining by welding in areas (1) and (2).
- In the areas (2), observe the procedure for replacing spot-welded adhesive joints from the series.NOTE: TECHNICAL INFORMATION
Adhesive technology in the area of the outer skin (not for structural adhesion):
The bonding surfaces of the new parts may not sharpened or ground.
For more information see: 41 00... BMW bonding instructions - Prepare areas (3) for joining by bonding.
Renew T-bolt
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Take the quantity and position from the component to be renewed.
- Renew T-bolts (1).
Parts: T-bolt
- Weld the T-bolt (1) onto the new part.