Installing the positive battery cable from the remote positive terminal to the starter

• Insert and position the positive battery cable (3)  .
• Renew the cable ties (2)  .

  Parts:  Cable tie

• Tighten the cable tie.
• Cut off the protruding end of the cable ties.
• Engage the positive battery cable (3)  on the holder (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nut (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the plug connection (1)  on the solenoid switch and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the positive battery cable (3)  on the stud bolt of the remote positive terminal.
• Engage the positive battery cable (3)  on the holder (2)  .
• Tighten nut (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the cover (1)  in a downwards direction.
• Check the detents (2)  are seated correctly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALL FRONT STIFFENING PLATE .
• Refer to INSTALL REAR UNDERBODY PROTECTION .
• Refer to INSTALLING CONTROL UNIT HOLDER FOR CYLINDERS 1 TO 4 .
• Refer to INSTALLING THE COVER OF THE RIGHT DME CONTROL UNIT .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .