Install the positive battery cable from the remote positive terminal to the alternator
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING THE COVER OF THE RIGHT DME CONTROL UNIT .
- Refer to REMOVING THE CONTROL UNIT BRACKET FOR CYLINDERS 1 TO 4 .
- Refer to REMOVING RIGHT INTAKE FILTER HOUSING WITH RIGHT FRONT-END STRUT .
- Refer to PARTIALLY RELEASING THE RIGHT CHARGE AIR LINE .
- Refer to REMOVE THE CLEAN AIR PIPE OF CYLINDER BANK 1 .
- Refer to RELEASING LEFT CHARGE AIR LINE PARTIALLY .
- Feed in and install positive battery cable.
- Connect plug connection (3) and lock.
- Position the positive battery cable on the alternator.
- Tighten nut (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Positive battery cable to alternator | ||
|---|---|---|
| M8 | tightening torque | 19 Nm |
- Attach cover panel (1) .
- Tighten down screw (4) .
TIGHTENING TORQUE SPECIFICATIONS
| Wiring harness to cylinder head cover | ||
|---|---|---|
| M6x16 screw | tightening torque | 10 Nm |
- Position ground cable (2) .
- Tighten nut (3) .
TIGHTENING TORQUE SPECIFICATIONS
| Ground cable to hold-down device | ||
|---|---|---|
| Nuts | Tightening torque | 5.5 Nm |
- Connect and lock the plug connection for the camshaft position sensors (1) .
- Clip in the cable clip (1)
.
- Engage the positive battery cable on the holders (1)
.
- Feed in the positive battery cable (2) on the stud bolt on the remote positive terminal.
- Tighten nut (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Positive battery cable | ||
|---|---|---|
| Positive pole screw | tightening torque | 15 Nm |
- Feed in the cover (1) in a downwards direction.
- Check the detents (2) are seated correctly.