Install the rear top cross connection
- Slightly pull the support (3) forward and insert the cross connection (4) .
- Tighten down screws (1) and (2) .
The screw (2) (M10x40) is installed on the right-hand side only.
TIGHTENING TORQUE SPECIFICATIONS
| Rear top cross connection to wheel arch carrier support | ||
| Torx screw M8x30 | Tightening torque | 19 Nm |
| Torx screw M10x40 | Tightening torque | 19 Nm |
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Hood lock support to support for bumper cover and/or to top rear cross connection | ||
| M8x25 | Tightening torque | 19 Nm |
| Torx bolt | Tightening torque | 19 Nm |
| Hexagon screw M8 | Tightening torque | 19 Nm |
Follow-up work
- Refer to INSTALLING LEFT INTAKE PORT .
- Refer to INSTALLING RIGHT AIR DUCT .
- Refer to INSTALLING THE LEFT-HAND AIR DUCT .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING FANFARE HORN, RIGHT .
- Refer to INSTALLING THE WHEEL ARCH COVER ON THE FRONT LEFT AND BOTTOM RIGHT .
- Refer to INSTALLING THE FANFARE ON THE LEFT SIDE .
- Refer to INSTALLING THE CENTER TOP CROSS CONNECTION .
- Refer to INSTALLING BOTH HEADLIGHTS .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to INSTALLING FRONT SECTION OF THE FRONT WHEEL ARCH COVER (PARTIALLY REMOVED) .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .
- Refer to ADJUSTING HEADLIGHTS .