Install the seat belt finisher strip
- Install the seat belt finisher strip (1) and in this process, insert the end fitting.
- Insert the seat belt finisher strip (1) at the rear into the guides (3) .
- Clip in the seat belt finisher strip (1) in the clips (2) .
- Make sure that seat belt finisher strip (1)
is correctly fitted against the edge protection.NOTE: TECHNICAL INFORMATION
Component is encoded against incorrect assembly. - Mount end fitting (2) .
- Replace the screw (1)
.
Parts: Screw
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATIONS
| End lining to body | ||
| M10 Replace screw. |
Tightening torque | 42 Nm |
Follow-up work
- Refer to INSTALLING C-PILLAR TRIM PANEL .
- Refer to REMOVING REAR SEAT BACKREST .
- Refer to INSTALLING THE REAR SEAT .