Installing the holder for the Digital Motor Electronics control unit on the right

• Insert and install the holder (2) for the DME control unit on the left.
• Tighten down screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the integrated power supply module (1) into the holder and lock the lock (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE DME CONTROL UNIT FOR CYLINDERS 1 TO 6 .
• Refer to CHECKING THE COOLANT LEVEL IN THE LOW-TEMPERATURE COOLANT CIRCUIT AND TOPPING UP, IF NEEDED .
• Refer to INSTALLING COVER FOR THE RIGHT DME CONTROL UNIT .
• Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .