11 13 020 Removing and Installing/Replacing Lower Oil Sump Section (N63O1)

Necessary Preliminary Tasks:

Unlock Plug Connection (1) On Oil Level Sensor and Disconnect.

Release Bolts Along Line (2).

Tightening torque 11 13 2AZ .

Remove Lower Oil Sump Section.

Installation Note:

Clean Sealing Surfaces.

Replace Gasket.

Replace Screws.

Fig 1: Identifying Connector and Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

When Replacing Oil Sump Bottom Section:

Convert Oil Level Sensor.

Replace Sealing Ring.