11 13 020 Removing and Installing/Replacing Lower Oil Sump Section (N63)
Necessary Preliminary Tasks:
- Remove Underbody Protection At FRONT and REAR .
- Release Oil Drain Plug and Drain ENGINE OIL .
- Remove STIFFENING PLATE (All-Wheel Drive Vehicle, F12, F13).
Unlock Plug Connection (1) On Oil Level Sensor and Disconnect.
Release Screws (2) Along Line.
Tightening torque 11 13 3AZ .
Remove Lower Oil Sump Section (3).
Installation Note:
Clean Sealing Surfaces.
Replace Gasket.
Replace Screws.
When Replacing Lower Oil Sump Section:
Convert Oil Level Sensor.
Replace Sealing Ring.
NOTE:
Procedure with All-Wheel Drive.
Unlock Plug Connection (1) On Oil Level Sensor and Disconnect.
Release Screws (2) Along Line.
Tightening torque 11 13 3AZ .
Remove Lower Oil Sump Section (3).
Installation Note:
Clean Sealing Surfaces.
Replace Gasket.
Replace Screws.
When Replacing Lower Oil Sump Section:
Convert Oil Level Sensor.
Replace Sealing Ring.