41 14 030 Stripping Operations - Replacing Front Right Wheel Arch

NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.

Disconnect battery earth lead (FR number: 61 20 900)
Remove bumper trim (job number: 51 11 156
Remove bumper support (FR number: 51 11 050)
Remove headlight (FR number: 63 12 010)
Remove radiator (FR number: 17 11 000)
Remove air conditioning capacitor (FR number: 64 53 550)
Remove and install charge air cooler (job number: 17 51 000)
Remove hydraulic steering cooling loop (FR number: 17 11 370)
Remove intake silencer housing (FR number: 41 35 111)
Remove coolant expansion tank (job number: 17 11 100)
Remove wheel arch cover (front section) (FR number: 51 71 038)
Remove wheel arch cover (rear section) (FR number: 51 71 039)
Front axle complete with engine and transmission (FR number: 31 10 001)
Remove engine compartment lid seal mounting (job number: 51 76 035)
Remove engine compartment lid (job number 41 61 000)
Remove engine compartment lid hinge on right (job number: 41 61050)
Remove right side wall (FR number: 41 35 055)
Remove top right wishbone (FR number: 31 12 003)
Remove right suspension cross-brace (job number: 51 71 346)
Remove bulkhead sound insulation
Remove fan housing for heating and air-conditioning unit (FRU number: 64 11 545)
Remove air conditioning refrigerant lines.
Release right wiring harness
Partially release/remove thermal protection