51 13 316 Removing and installing or replacing trim strip on roof gutter at left or right
Special tools required:
IMPORTANT:
Make sure that body is not damaged.
Open door at front and rear.
Release edge protection in C-pillar area.
Pull off gasket (1) in rear area toward the bottom.
Release screw (2).
Tightening torque 51 13 6AZ .
Starting from the rear, use special tool 00 9 325 to detach trim strip (1) from clips (2).
Installation note:
To avoid leaks and noises, check all clamps (2) for visible damage.
If necessary, replace faulty clips (2).
Align clamps (2) on body and fit trim strip (1).
IMPORTANT:
- Carry trim strip by its middle section only (risk of damage)
- Perform installation work with a second person helping
- Prepositioning of trim strip
- Ensure gutter strip runs parallel to side frame (risk of breakage)