51 47 315 Removing and installing/replacing front carpet for passenger compartment
Necessary preliminary tasks:
- Remove trims from bass speaker on left and right. See DRIVER'S SIDE (UNDER FRONT SEAT) and PASSENGER'S SIDE (UNDER FRONT SEAT) .
- Remove CENTER CONSOLE SUPPORT
- Remove A-pillar trim panel, bottom left and right. See A-PILLAR, RIGHT and A-PILLAR, LEFT .
- Remove COMPLETE ACCELERATOR PEDAL MODULE
Cut out carpet (1) along heater box.
IMPORTANT:
Choose cut so that center console conceals cutting edge after installation. Do not damage any cables or air ducts when cutting.
Remove carpet (1) toward rear/top and if necessary feed out cable.
Installation:
Cutouts (1) serves as locators when installing carpet (2).
Replacement
Modify footrest, driver's side.
Unclip footwell net (1) on front passenger side.
Installation:
If necessary, replace damaged retaining clips.