52 14 040 Removing and installing/replacing outer cover on left or right front seat

If necessary, move seat fully forwards and upwards.

Remove trim:

1. Unclip at rear towards top side
2. Pull on belt opening to one side
3. Bend trim open slightly at top and bottom on actuating unit
4. Bend open slightly at top and bottom and pull outwards a little
   Fig 1: Removing Trim

   Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Retaining clips must not be damaged.

Fig 2: Identifying Retaining Clips

Courtesy of BMW OF NORTH AMERICA, INC.

1. Unclip front cover in marked area.
2. Unclip cover in marked area from operating unit.
3. Unclip center cover in marked area.
4. Remove the cover backward from the seat mechanism.
   Fig 1: Removing Cover Backward From Seat Mechanism

   Courtesy of BMW OF NORTH AMERICA, INC.

Catches and guides in marked area must not be damaged.

Replace facing panel if necessary.

Fig 2: Identifying Catches And Guides In Marked Area

Courtesy of BMW OF NORTH AMERICA, INC.