22 11 110 Replacing left engine support arm (N55)

Necessary preliminary work: 

• Secure engine in installation position  . See 11 00 670 SECURING ENGINE IN INSTALLATION POSITION (N55)
• Remove rear UNDERBODY PROTECTION
• Remove left COVER
• Remove rear left CHARGE AIR DUCT

Release screws (3).

Place heat exchanger (4) to one side.

Fig 1: Identifying Heat Exchanger Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove engine support arm.

Tightening torque 22 11 3AZ .

Fig 2: Identifying Engine Support Arm Screws

Courtesy of BMW OF NORTH AMERICA, INC.