51 16 165 Removing and installing/replacing complete center console

Necessary preliminary tasks:

IMPORTANT: Read and comply with notes on HANDLING WIRING HARNESSES AND CABLES .

Unscrew nuts (1).

Tightening torque 51 16 3AZ .

Disconnect plug connections (2), depending on version.

Fig 1: Identifying Plug Connections And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 51 16 4AZ .

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 51 16 3AZ .

Detach wiring harness (2) from central console mount.

Fig 3: Identifying Wiring Harness And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Raise the center console (1) rear and feed out gaiter (2).

If necessary, release further plug connections and cable clips from below on center console (1).

Remove center console (1) to the rear/top.

Installation note:

Feed center console (1) correctly into dashboard including guides (4).

Fit center console (1) on the side correctly at rear of trim panel for pedal mechanism and trim panel at bottom of dashboard.

Make sure wiring harness (3) is in correct position.

Fig 4: Removing Center Console

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement (depending on version):

Modify air ducts (1)
Modify retaining bracket (2)
Modify SIDE COVER
Change over CENTER ARMREST .
Modify INSERT IN STORAGE COMPARTMENT
Modify BASE PLATE for telephone
Modify LED

Fig 5: Identifying Air Ducts And Retaining Bracket
Courtesy of BMW OF NORTH AMERICA, INC.