23 00 Transmission in general
Note: note screw material, length and thread for torque specification.
TIGHTENING TORQUE SPECIFICATIONS (1 OF 2)
TIGHTENING TORQUE SPECIFICATIONS - TRANSMISSION IN GENERAL
| Refer to TRANSMISSION DESIGNATIONS | Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|---|
| 1AZ | Transmission to engine (Aluminium screws/bolts are not magnetic). | Replace aluminium screws. Jointing torque and angle of rotation must be observed without fail. |
|||
| N55 | M12 | Jointing torque | 25 Nm | ||
| Angle of rotation | 130 ° | ||||
| N55/N47/B47/N20/S55 | M8 | Steel screw | 19 Nm | ||
| N55/N47/B47/S55 | M12 | Steel screw | 66 Nm | ||
| N55 | M10 | Steel screw | 38 Nm | ||
| N20/S55 | M10 | Steel screw | 56 Nm | ||
| Steel screws with Torx head | I-transmission | M8 | 19 Nm | ||
| I-transmission | M10x40-8.8 | 38 Nm | |||
| I-transmission | M10x50-10.9 | 56 Nm | |||
| I-transmission | M12 | 66 Nm | |||
| 2AZ | Oil drain plug/oil filler plug | K transmission (without S55) | Hexagon socket | 40 Nm | |
| K transmission (only S55) | Hexagon socket | 43±4 Nm | |||
| I-transmission | Hexagon socket | 43±4 Nm | |||
| I-transmission | M12x1.5 | 25 Nm | |||
| I-transmission M18x1.5 | Steel screw without seal | 45 Nm | |||
| 3AZ | Cover plate to transmission | I-transmission | 7.6 Nm | ||
TIGHTENING TORQUE SPECIFICATIONS (2 OF 2)
TIGHTENING TORQUE SPECIFICATIONS - TRANSMISSION IN GENERAL
| Refer to TRANSMISSION DESIGNATIONS | Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|---|
| 1AZ | Transmission to engine (Aluminium screws/bolts are not magnetic). | Replace aluminium screws/bolts. Jointing torque and angle of rotation must be observed without fail |
|||
| N53/N55 | M12 | Jointing torque | 25 Nm | ||
| Angle of rotation | 130 ° +20 ° | ||||
| M10X85 | Jointing torque | 20 Nm | |||
| Angle of rotation | 180°- 200 ° | ||||
| N53/N55 | M8 | Steel screw | 19 Nm | ||
| N53/N55 | M12 | Steel screw | 66 Nm | ||
| K transmission | M8 | Steel screw | 19 Nm | ||
| K transmission | M12 | Steel screw | 66 Nm | ||
| I-transmission N13 | M10 | Steel screw | 38 Nm | ||
| I-transmission N20 | M10 | Steel screw | 56 Nm | ||
| 2AZ | Oil drain plug/oil filler plug | H/G-transmission | M18x1.5 hexagon socket | 35 Nm | |
| H/I transmission | M12x1.5 | 25 Nm | |||
| I-transmission | M18x1.5 Steel screw without seal | 45 Nm | |||
| K transmission | Hexagon socket | 40 Nm | |||