22 32 050 Replacing cross-member for transmission mounting (N55) AWD

Necessary preliminary tasks  :

• Remove rear UNDERBODY PROTECTION .
• Release the heat shield.
• Support transmission with lifter.
• Release holder for exhaust system on transmission cross-member.

Release screws.

Tightening torque 22 32 3AZ .

Fig 1: Locating Underbody Protection Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Tightening torque 22 32 6AZ .

Pull out screw (2).

Move transmission cross member (3) in direction of arrow and remove screw (2).

Remove transmission cross member.

Fig 2: Locating Transmission Cross Member Mark

Courtesy of BMW OF NORTH AMERICA, INC.