22 32 001 Replacing rubber mount for transmission mounting (N20, N26) version 2

Necessary preliminary tasks :

Unscrew nuts (1).

Tightening torque 22 32 2AZ .

Release screws (3).

Tightening torque 22 32 3AZ .

Remove gearbox cross member (2).

Remove rubber mount from transmission cross-member.

Tightening torque 22 32 4AZ .

Fig 1: Identifying Gearbox Cross Member, Screws And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Note the installation position of rubber mount (1) relative to transmission cross-member (2).

Arrow in illustration shows in direction of engine/front of vehicle.

Fig 2: Removing Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.