18 00 020 Removing and installing complete exhaust system (N55)

Special tools required :

31 2 220

WARNING: Risk of burning!
Only perform this repair work after engine has cooled down.
Danger of injury!
Removal of the exhaust system must be carried out with the assistance of a second person.

Necessary preliminary tasks :

Remove rear TRAILING LINK .
Remove TENSION STRUT (rear axle) left or right.

Support exhaust system with jack and special tool 31 2 220 or with a suitable lever and secure against falling out.

Fig 1: Supporting Exhaust System Using Special Tool (31 2 220)

Courtesy of BMW OF NORTH AMERICA, INC.

Release clamp (1).

Tightening torque 18 31 1AZ .

Fig 2: Identifying Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 18 20 2AZ .

Fig 3: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

If fitted :

Release screws (1).

Tightening torque 18 31 3AZ .

Remove reinforcement plate (2).

Fig 4: Identifying Reinforcement Plate Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten nut.

Tightening torque 18 20 3AZ .

Fig 5: Identifying Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector from exhaust flap and pull off.

Slacken nut (2).

Tightening torque 18 20 3AZ .

Lower and remove exhaust system with assistance of a second person.

Fig 6: Identifying Exhaust Flap Connector And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note :

Check rubber mount for damage.

If necessary, replace damaged rubber mounts.

Check exhaust system for leaks.