11 22 500 Removing and installing/replacing flywheel (N55)
Special tools required :
IMPORTANT:
Aluminium screws/bolts must be replaced each time they are released
.
Aluminium screws/bolts are permitted with and without color coding (blue).
For reliable identification:
Aluminium screws/bolts are not magnetic .
Jointing torque and angle of rotation must be observed without fail (risk of damage) .
Aluminium screws/bolts are permitted with and without color coding (blue).
For reliable identification:
Aluminium screws/bolts are not magnetic .
Jointing torque and angle of rotation must be observed without fail (risk of damage) .
Necessary preliminary tasks :
- Remove transmission. See appropriate procedure:
- Remove CLUTCH (if fitted).
Automatic transmission :
Secure flywheel (1) with special tool 11 9 260 .
Unfasten flywheel bolts.
Tightening torque 11 22 1AZ .
Installation note :
Flywheel (1) is secured with an dowel pin.
Manual gearbox :
Fasten dual-mass flywheel with special tool 11 9 260 and 11 9 265 .
Release flywheel bolts with special tool 11 4 180 /
Tightening torque 11 22 2AZ .
Installation note :
Fit new flywheel bolts.
Clean all threads for flywheel bolts in crankshaft.
Installation note :
Pay attention to dowel pin.
Installation note :
Ensure installed position of magnet wheel is correct.
Assemble engine.