11 22 500 Removing and installing/replacing flywheel (N20, N26)

Special tools required  :

• 11 9 260
• 11 4 180

Necessary preliminary tasks  :

• Remove transmission. See appropriate procedure:
  • REMOVING AUTOMATIC TRANSMISSION (RWD) ,
  • REMOVING AUTOMATIC TRANSMISSION (AWD) ,

  - or - 

  • REMOVING MANUAL TRANSMISSION
• Remove CLUTCH .

Automatic transmission  :

Secure flywheel (1) with special tool 11 9 260 .

Unfasten flywheel studs.

Tightening torque 11 22 1AZ .

Installation note  :

Flywheel (1) is secured with an dowel pin.

Clean all threads for flywheel bolts in crankshaft.

Fit new flywheel bolts.

Manual transmission  :

Fasten dual-mass flywheel with special tool 11 9 260 .

Release flywheel bolts with special tool 11 4 180 /

Tightening torque 11 22 2AZ .

Installation note  :

Flywheel is secured with a dowel pin.

Fit new flywheel bolts.

Clean all threads for flywheel bolts in crankshaft.

Remove flywheel.

Installation note  :

Pay attention to dowel pin.

Ensure installed position of magnet wheel is correct.

Assemble engine.