REP-TAT-P-1161-01 Removing the intake plenum

NOTE: TECHNICAL INFORMATION 
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.

• Unclip tank vent line (1) in the marked area.
• Unlock and detach engine ventilation line (2).
• Unscrew the bolt (3) and unclip the tank vent line (4) in the marked area.
• Remove tank vent line (4).
• Unscrew the bolts (5) and set the engine wiring harness aside.
• Unclip cable (6) in marked areas.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen tank vent line (1) in marked area from intake plenum.
• Unlock closure (2) and detach the coolant line.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock and disconnect connector (1).
• Unclip the wiring harness in the marked areas.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screws (8).
• Loosen screws in the order (7) to (1).
• Slightly raise air intake header.
  Fig 1: Intake Plenum Screws Loosening Sequence

  Courtesy of BMW OF NORTH AMERICA, INC.
• Unlock the closure (1) and detach the coolant feed line.
• Unlock the closure (2) and detach the coolant return line.
• Unclip the wiring harness from the clamp (3).

NOTE: TECHNICAL INFORMATION 
Additional coolant can leakage. Make sure that no coolant enters the intake port of the cylinder head.

• Remove intake plenum.

Courtesy of BMW OF NORTH AMERICA, INC.