REP-TAT-P-1153-02 Install heat management module

Replace the O-Ring (1) and gasket (2).
Parts: O-ring and gasket

Courtesy of BMW OF NORTH AMERICA, INC.
Clean sealing surface (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Feed out the heat management module (1) to the outside rear out of the component carrier (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten the screws (1) to (3).

TIGHTEN TORQUES SPECIFICATIONS

Heat management module to engine block
Captive screws	8 Nm

Fig 1: Heat Management Module Screws Tightening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.

Insert coolant hose onto the heat management module and fasten with the clamp (5).
See that the marking lines up.

NOTE: TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.