REP-TAT-P-1112-01 Remove cylinder head

Release screw (1) and lay the grounding cable to one side.
Remove screw (2) and lay the wiring harness to one side.
Release screw (3) and push the acoustic cover carefully towards the rear.

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock and disconnect connector (1).
Release screw (2) and lay the grounding cable to one side.

Courtesy of BMW OF NORTH AMERICA, INC.
Rotate intake camshaft, if necessary in the position shown.
The recess (2) must point up.
Loosen screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Shift camshaft sensor wheel (1) in direction of cylinder 1 and feed out from the intake camshaft.

Courtesy of BMW OF NORTH AMERICA, INC.
Unscrew bolts (1) to (5).

Fig 1: Camshaft Sensor Wheel Bolts Loosening Sequence
Courtesy of BMW OF NORTH AMERICA, INC.
Undo the screws using the special tool 0 495 747 (11 8 580) in the order (14) to (1).

Fig 2: Cylinder Head Screws Loosening Sequence
Courtesy of BMW OF NORTH AMERICA, INC.
Detach timing chain from the guide rail (1).
Feed out guide rail (2) when removing the cylinder head.

Courtesy of BMW OF NORTH AMERICA, INC.
Attach special tool 0 490 567 (11 0 020) to workshop crane.
Lift out the cylinder head (1) and the exhaust turbocharger with the help of a second person, using the workshop crane and the special tool 0 490 567 (11 0 020) .

Courtesy of BMW OF NORTH AMERICA, INC.