11 61 051 Replace intake plenum: Notes
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- For additional information see: LIFTING THE VEHICLE USING A VEHICLE HOIST .
CAUTION:
Materials harmful to health.
Contact with fluids harmful to health!
Contact with fluids harmful to health!
- Note and follow safety instructions on containers.
- Conduct all work in appropriate personal protective equipment only.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
NOTE:
TECHNICAL INFORMATION
Notes for WORKING ON THE COOLING SYSTEM form the basis of these repair instructions and must be complied with at all times.
Notes for WORKING ON THE COOLING SYSTEM form the basis of these repair instructions and must be complied with at all times.
Preliminary work:
- Disconnect all battery ground leads
- Refer to REMOVING THE ACOUSTIC COVER
- Remove the cover in the left engine compartment
- Remove the right cover in the engine compartment
- Refer to REMOVING TRAILING LINK AT SPRING STRUT DOME
- Remove the sound insulation on the bulkhead upper part center
- Remove ACOUSTIC COVER AT REAR
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION
- Refer to DRAINING THE COOLANT FROM THE LOW-TEMPERATURE COOLING SYSTEM
- Uninstall cover for the DME control unit
- Refer to REMOVING THE INTEGRATED POWER SUPPLY MODULE (PDM)
- Disconnect the connector from the DME control unit and from the power distribution module (PDM)
- Refer to REMOVING THE DME CONTROL UNIT
- Refer to REMOVING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT
- Refer to REMOVING TANK VENT VALVE
- Refer to REMOVING THE THROTTLE BODY
Follow-up work:
- Refer to INSTALLING THE THROTTLE BODY
- Refer to INSTALLING THE TANK VENT VALVE
- Refer to INSTALLING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT
- Refer to INSTALLING THE DME CONTROL UNIT
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM)
- Connect the connector to the DME control unit and the power distribution box (PDM)
- Install cover for the DME control unit
- Refer to CONNECT THE COOLANT HOSE TO THE RADIATOR OF THE LOW-TEMPERATURE COOLANT CIRCUIT
- Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLER DEVICE
- Refer to INSTALLING ACOUSTIC COVER AT REAR
- Install the sound insulation on the bulkhead upper part center
- Install tension strut on spring strut dome. Jointing torque: 56 Nm, angle of rotation: 90° NOTE: Replace screws.
- Refer to INSTALLING ACOUSTIC COVER
- Install the cover in the engine compartment on the right
- Install the cover in the engine compartment on the left
- Connect all battery ground leads
- Refer to BLEEDING THE LOW-TEMPERATURE COOLING SYSTEM
- Install the front underbody protection