REP-TAT-P-1114-02 Install front engine encapsulation

• Install the engine encapsulation (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Correctly route the wiring harness (3) and clip it in at the highlighted areas.
• If necessary, position the ground cable and secure it with the screw.

TIGHTEN TORQUES SPECIFICATIONS

Front ground cable to cylinder head
M6	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1) and (2).

NOTE: TECHNICAL INFORMATION 
Make sure that the connections are locked correctly. The locks must engage audibly.

• Connect the ventilation line (2) with the intake plenum.
• Connect the ventilation line (1) with the tank vent valve and clip it in at the highlighted area.

Courtesy of BMW OF NORTH AMERICA, INC.