11 12 115 Removing and installing/replacing corrosion protection cover: Notes
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work:
- Refer to REMOVING THE ACOUSTIC COVER
- Remove the cover in the left engine compartment
- Remove the right cover in the engine compartment
- Refer to REMOVING TRAILING LINK AT SPRING STRUT DOME
- Remove the sound insulation on the bulkhead upper part center
Follow-up work:
- Install the sound insulation on the bulkhead upper part center
- Install tension strut on spring strut dome. Jointing torque: 56 Nm, angle of rotation: 90° NOTE: Replace screws.
- Install the cover in the engine compartment on the left
- Install the cover in the engine compartment on the right
- Refer to INSTALLING ACOUSTIC COVER