REP-TAT-P-1153-02 Install connecting bracket on the engine block

• Clean sealing surface (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Install connecting brackets (2) and connect to connector (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Position connecting brackets on engine block and fasten using screws (1).

TIGHTENING TORQUES SPECIFICATION

Connecting bracket to engine block
M6 x 25	10 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

• Insert coolant hose on the connecting bracket.

  The marks must be aligned.

• Fasten the coolant hose using the hose clamp (2).
• Clip the wiring harness to the connecting bracket using clamp (1).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Make sure that the connections are locked correctly. The locks must engage audibly.

• Lock coolant hose (1) and insert on connecting bracket.

Courtesy of BMW OF NORTH AMERICA, INC.