REP-TAT-P-1113-25 Replacing oil sump: remount the oil-level sensor

NOTE: RISK OF DAMAGE 
Electrostatic discharge. 
Damage to or destruction of electrical components. 

• Leave electrical components in original packaging until just before they are installed. Use the original packaging only for any return shipments. Always package removed components straight away.
• Read and comply with user information on using the associated special tool 12 7 060.
• Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
• Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
• For additional information see: NOTES ON ESD PROTECTION (ELECTROSTATIC DISCHARGE)

• Loosen nuts (2).
• Remove the oil-level sensor (3).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install the oil-level sensor (3).
• Tighten nuts (2).

TIGHTENING TORQUES SPECIFICATION

Oil-level sensor to oil sump
M6	Joining torque	2 Nm
	tightening torque	8.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.