22 11 100 Replacing right engine support arm

WARNING: This page is about a different car, the 2018 BMW 340i and 2017 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Secure ENGINE IN INSTALLATION POSITION .
Remove EXHAUST SYSTEM .
Remove underbody protection at FRONT and REAR .
Refer to REMOVE INTAKE SILENCER HOUSING .
Remove the CATALYTIC CONVERTER .

Removal:

Release screws (1).

Remove engine support arm (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install engine support arm (2).

Tighten down screws (1).

Tightening torque 22 11 3AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install the CATALYTIC CONVERTER .
Install INTAKE SILENCER HOUSING .
Install underbody protection at FRONT and REAR .
Install EXHAUST SYSTEM .