REP-TAT-P-1141-02 Installing the hydraulic valve for the oil pressure control

• Check the O-ring (1) for damage.
• If necessary, replace the hydraulic valve.

Courtesy of BMW OF NORTH AMERICA, INC.

• Install the hydraulic valve (2).
• Tighten down screw (1).

TIGHTENING TORQUES SPECIFICATION

Hydraulic valve to crankcase
M6 x 18	tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connector (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the transmission bolt (1).

TIGHTENING TORQUES SPECIFICATION

Transmission to engine
M12 x 100	tightening torque	66 Nm

Courtesy of BMW OF NORTH AMERICA, INC.