REP-TAT-P-1112-25 Remounting the camshaft position sensors of the intake camshaft and of the exhaust camshaft
- Loosen screw (1).
- Unscrew and remove the camshaft position sensor (2) for the intake camshaft.
- Loosen screw (3).
- Guide the camshaft position sensor (4) of the exhaust camshaft out and remove.
- Check the sealing ring (1) for damage, replace it if necessary.
- Thread in and install the camshaft position sensor (2) of the intake camshaft.
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Camshaft position sensor to cylinder head cover | ||
|---|---|---|
| TS5x20 | Tightening torque | 4 Nm |
- Guide the camshaft position sensor (4) of the exhaust camshaft in and install.
- Tighten down screw (3).
TIGHTENING TORQUES SPECIFICATION
| Camshaft position sensor to cylinder head cover | ||
|---|---|---|
| TS5x20 | Tightening torque | 4 Nm |