51 42 001 Replacing left or right rear door trim panel
Necessary preliminary work:
- Remove rear DOOR TRIM PANEL
Following parts must be fitted on new door trim panel (if necessary as new part):
- DOOR OPENER (always fit new part)
- ARM SUPPORT
- DOOR HANDLE
- SPEAKER COVER
Depending on version:
- ROLLER SUNBLIND
- FOOTWELL LIGHT
- LED for door opener
- Tweeter with holder (described below)
Version with tweeter:
Aperture for tweeter must be sawn out.
IMPORTANT:
Risk of damage!
Saw only through carrier material (2) and not through covering (3).
Cut through covering (3) with knife.
Saw only through carrier material (2) and not through covering (3).
Cut through covering (3) with knife.
Saw out aperture at mark (1) with 50 mm dia. jigsaw.
Fit holder (1) and secure with lock washers (2).
Saw off all pins (3) to dimension (A).
Dimension (A) = 2 mm
Mount tweeter cover from outside.
Install TWEETER .