Installing the coolant feed line for the exhaust turbocharger
- Replace the O-rings (1).
Parts: O-rings
- Position the coolant feed line (3) at the engine block.
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Coolant feed line to crankcase | ||
| M6 x 12 | Tightening torques | 8 Nm |
- Position the coolant feed line (3) at the exhaust turbocharger.
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Coolant feed line/coolant return line to exhaust turbocharger | ||
| M6 X 12 | tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING THE COMPLETE EXHAUST SYSTEM .
- Refer to INSTALLING CATALYTIC CONVERTER .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING THE OXYGEN SENSOR MONITOR .
- Refer to INSTALLING LAMBDA OXYGEN SENSOR .
- Refer to INSTALLING CORROSION PROTECTION COVER .
- Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE BULKHEAD UPPER PART .
- Refer to REMOVING/INSTALLING TRAILING LINK AT TENSION STRUT TOWER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE DESIGN COVER .
- Refer to CONNECTING THE COOLANT LINE TO THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLER DEVICE .
- Refer to BLEEDING THE HIGH-TEMPERATURE COOLANT SYSTEM .
- Refer to CHECKING THE HIGH-TEMPERATURE COOLING SYSTEM FOR WATERTIGHTNESS .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .