Removing and installing/replacing trim cover on front door window frame, left or right

Necessary preliminary tasks:

Pull rubber window seal (1) out of rear window guide.

Unfasten screws (2).

Push cover (3) down slightly and unfeed rubber window seal (1) toward the top.

Then feed cover (3) upward out of the door.

Installation note:

if necessary, replace faulty plastic nuts for screws (2).

Wet rubber window seal (1) prior to fitting with APPROVED LUBRICANT .

Courtesy of BMW OF NORTH AMERICA, INC.

Make sure rubber window seal (1) is correctly seated on cover (3).

Installation note:

Sealing (1) on cover (2) must not be damaged or missing.

Courtesy of BMW OF NORTH AMERICA, INC.