Installing the sound insulation on the rear door

NOTE: TECHNICAL INFORMATION
Notes on the sound insulation must be strictly observed for these repair instructions.
For additional information see: NOTES FOR BONDING SOUND INSULATION (SI), DOORS .

Reinstalling the sound insulation (rear door)

Check the sound insulation (2) for damage and replace if necessary.
Route the butyl rope with Ø 4 mm (sourcing reference BMW Group Parts) along the previous routing of the butyl rope (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing the sound insulation

NOTE: TECHNICAL INFORMATION
Bonding surfaces must be dry and free of dust and grease. After the adhesive area has been cleaned, it must no longer be taped with bare hands.

Remove any butyl rope residue from the door and clean the adhesive area.
Observe 1 min air drying time.
Attach the 6 mm butyl rope (3) (sourcing reference: BMW Group Parts) on the mark (2) of the sound insulation (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Heat up the butyl rope (1) with the hot air blower and press on the sound insulation (4) all around using a hand roller.
Route lines (3) and connect the connector (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE LEFT OR RIGHT REAR DOOR TRIM PANEL .
Refer to INSTALLING THE COVER ON THE REAR LEFT OR RIGHT DOOR HANDLE .
Refer to INSTALLING THE REAR POWER WINDOW SWITCH .