Remove front entrance cover strip
NOTE:
Description is for left component only. Procedure on the right side is identical.
NOTE:
RISK OF DAMAGE
Bending of plastic components.
Application of too much force can lead to bending of plastic components.
Bending of plastic components.
Application of too much force can lead to bending of plastic components.
- Place special tool directly beside the mounting clip.
- Continue unclipping the part without using the tool if possible.
- Unclip the front door sill cover strip (1) at the clips (2) using the special tool 0 496 569 (00 9 325) in the direction of arrow starting from the rear.
- If applicable, unclip the clips (1) from the floor panel (2).