11 12 040 Removing and installing all ignition coil and injector wells (N55 Hybrid)

WARNING: Compliance with the following points is mandatory before beginning work:

Necessary preliminary work:

Release screws (1).

Tightening torque: 11 12 8AZ .

Fig 1: Identifying Injector Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Check fitting bushes (1) for damage.

Installation note:

Replace gasket (2).

Fig 2: Identifying Fitting Bushes And Gasket

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.