12 14 523 Replacing pulse sensor on intake camshaft (N55)

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Release screws (1).

Slide cable channel (2) to one side.

Fig 1: Identifying Screws And Cable Channel

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Release screw.

Tightening torque: 13 62 1AZ .

Remove pulse sensor (2).

Fig 2: Locating Pulse Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Delete fault memory.