11 36 655 Removing and installing/replacing both actuators (N20)
WARNING: This page is about a different variant/trim than selected.
Attention!
It is essential to observe conditions of absolute cleanliness when removing and installing the intake and exhaust actuators.
Possible malfunction if there is dirt contamination in the valves:
- Rough running
- OBD fault entry
- Exhaust gas emission characteristics.
- Low engine performance
Necessary preliminary tasks:
- Remove IGNITION COIL COVER
Disconnect plug connection (5) on intake actuator (6).
Release screws (4).
Tightening torque 11 36 2AZ .
Remove intake actuator (6) to the front.
Disconnect plug connection (2) on exhaust actuator (3).
Release screws (1).
Tightening torque 11 36 2AZ .
Remove exhaust actuator (3) to the front.
Assemble engine.
Check function of DME.