11 23 010 Removing and installing/replacing vibration damper (N20)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

NOTE: Engine removed:

Block crankshaft with special tool 11 9 260 .

Fig 1: Identifying Central Bolt And Special Tool (11 9 260)

NOTE: Engine installed with manual transmission:

Block crankshaft with special tool 11 8 180 .

Fig 2: Identifying Special Tool (11 8 180)

NOTE: Engine installed with automatic transmission:

Block crankshaft with special tool 22 2 742.

Feed in special tool, slide screw forward and tighten.

Fig 3: Identifying Special Tool (2 222 742)

Release screws (1).

Remove vibration damper.

Tightening torque 11 23 1AZ .

Fig 4: Identifying Vibration Damper And Screws

Assemble engine.