22 32 001 Replacing rubber mount for transmission mounting (automatic transmission)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release screws (1).

Tightening torque 18 31 6AZ .

Fig 1: Identifying Exhaust System Rubber Mount Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove heat shield (2).

NOTE: Shown without exhaust system for purposes of clarity. Exhaust system remains fitted.

Fig 2: Identifying Heat Shield Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (2).

Tightening torque 22 32 3AZ .

Release screws (1).

Tightening torque 22 32 4AZ .

Remove transmission cross member.

Remove rubber mount from transmission cross-member.

Fig 3: Identifying Transmission Cross Member Screws And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.