24 13 Transmission Extension, Bearings, Sealing Ring
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - TRANSMISSION EXTENSION, BEARINGS AND SEALING RING
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Slotted nut/output flange | A5S 310Z/A5S 440Z/A5S 560Z/A5S 325Z | 120 Nm | ||
| 2AZ Double hexagon nut/output flange | GA6HP26Z | up to 09/02 without sealing ring in output flange | 80 Nm | |
| GA6HP19Z/GA6HP26Z | from 09/02 with sealing ring in output flange | 60 Nm | ||
| GA8HP45Z | with sealing ring in output flange | 60 Nm | ||
| 3AZ Output shaft nut to output flange | GA6L45R | Replace nut from 01/11 Nut with screw locking in thread |
55 Nm |