24 34 022 Replacing sealing sleeve for transmission housing (GA8HP45Z)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

24 2 390

IMPORTANT:

Do not let skin come in contact with transmission oil and do not inhale fuel vapours.
Wear protective gloves.
Ensure adequate ventilation.

IMPORTANT: After completion of repair work, check TRANSMISSION OIL LEVEL .
Use only approved transmission oil .
Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary tasks:

Remove TRANSMISSION OIL SUMP .
IF REQUIRED, REMOVE OIL ACCUMULATOR .

Unlock and disconnect connector (1) by turning.

Fig 1: Disconnecting Connector

Insert special tool 24 2 390 in sealing sleeve (1).

Fig 2: Inserting Special Tool (24 2 390) In Sealing Sleeve

Release screw (1) and unlock sealing cup with slide (2).

Tightening torque 24 30 4AZ .

Fig 3: Releasing Sealing Cup

NOTE: Make a note of installation position of sealing sleeve.

Pull out sealing cup (1).

Installation note:

Fit sealing sleeve in position (lug on inner surface). Turn until lug engages in groove of transmission. Slide in sealing cup.

Lug on sealing sleeve must not be damaged!

Fig 4: Pulling Out Sealing Cup